No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an LSP Ingress to Deeply Parse IP Packets

Configuring an LSP Ingress to Deeply Parse IP Packets

This section describes how to enable an LSP ingress to deeply parse IP packets.

Context

After the entropy label function is enabled on the LSP ingress, the ingress uses IP header information to generate an entropy label and adds the label to the packets. The entropy label is used as a key value by a transit node to load-balance traffic. If the length of a data frame carried in a packet exceeds the parsing capability, the ingress fails to parse the IP header or generate an entropy label. Perform the following steps on the LSP ingress:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run load-balance identify entropy-label

    The LSP ingress is enabled to deeply parse IP packets.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19363

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next