No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Feature Description - Interface and Data Link 01

This is NE20E-S V800R010C10SPC500 Feature Description - Interface and Data Link
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Tunnel Interface

Tunnel Interface

Tunnels such as MPLS TE tunnels, and IPv6 over IPv4 tunnelsall use virtual interfaces called tunnel interfaces to forward packets. Before these tunnels can be used, tunnel interfaces must be created.

The source and destination addresses of a tunnel uniquely identify a tunnel. The destination address of a tunnel interface is the same as the source address specified by the remote tunnel interface. Ensure there is a reachable route between the source and destination tunnel addresses. The same source address and destination address cannot be configured on two or more tunnel interfaces using the same encapsulation protocol.

Tunnel interfaces can be configured with different encapsulation modes as required.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055118

Views: 2799

Downloads: 8

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next