Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
NON-ECMP PIM FRR Based on Multicast Static Route
NON-ECMP PIM FRR Based on Multicast Static Route
Service Overview
In a NON-ECMP network, the IGP LFA FRR function may fail to calculate unicast routes. To avoid multicast service failure, configure static main and backup routes to establish main and backup links.
Networking Description
PIM FRR function deployed on the user-access devices helps the network prevent multicast traffic congestion and maintain reliability. PIM FRR is used on the IPTV service network shown inFigure 4-48.
Figure 4-48 NON-ECMP PIM FRR for IPTV services
Feature Deployment
PIM FRR is used to transmit and protect IP multicast services. The process consists of the following stages:
Configure FRR based on multicast static routes.
Configure FRR based on multicast static routes on each node of the circle, so that each node can generate main and backup unicast routes.
Configure PIM FRR.
PIM FRR is configured on each node of the circle. When a user joins in, a main multicast forwarding entry and a backup multicast forwarding entry are generated. If the network operates normally, the protection nodes only receive the multicast traffic from main link and drop the traffic from backup link. If the main link fails, the protection nodes rapidly switch to the backup link to protect the multicast traffic.
Previous
