No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Feature Description - MPLS 01

This is NE20E-S V800R010C10SPC500 Feature Description - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Establishment of an LDP LSP

Establishment of an LDP LSP

Command-based LDP LSP Establishment

Establishing an LSP is actually binding FEC with the label, then advertising this binding to the adjacent LSR on LSP.Figure 3-5 shows the procedure for establishing an LSP using the downstream unsolicited (DU) and ordered modes.

Figure 3-5 LDP LSP establishment

The process of establishing an LDP LSP is as follows:

  1. If a label edge router (LER) on an MPLS network discovers a new direct route due to a network route change, and the address carried in the new route does not belong to any existing forwarding equivalence class (FEC), the LER creates a FEC for the address.

  2. If the egress has available labels for distribution, it distributes a label for the FEC and pro-actively sends a Label Mapping message to its upstream transit LSR. The Label Mapping message contains the assigned label and an FEC bound to the label.

  3. The transit LSR adds the mapping in the Label Mapping message to the label forwarding table and sends a Label Mapping message with a specified FEC to its upstream LSR.

  4. The ingress LSR also adds the mapping to its label forwarding table. The ingress LSR establishes an LSP and forwards packets along the LSP.

Proxy Egress LSP

A proxy egress extends an LSP to a non-LDP node. The extended LSP is called a proxy egress LSP. A penultimate LSR functions as a special proxy egress when penultimate hop popping (PHP) is enabled.

A proxy egress LSP can be established on a network with MPLS-incapable routers or in the Border Gateway Protocol (BGP) route load balancing scenario. For example, on the network shown in Figure 3-6, LSRA, LSRB, and LSRC, all except LSRD, are in an MPLS domain. An LSP is established along the path LSA -> LSRB -> LSRC. LSRC functions as a proxy egress and extends the LSP to LSRD. The extended LSP is a proxy egress LSP.
Figure 3-6 LDP LSP establishment

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055123

Views: 5812

Downloads: 21

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next