No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - IP Services 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - IP Services
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining ARP

Maintaining ARP

This section describes how to clear ARP statistics and monitor the operating status.

Clearing ARP Statistics

This section describes how to clear ARP statistics.

Context

Exercise caution when running reset commands.
  • Static ARP entries cannot be restored after they are cleared.
  • The IP-MAC mapping is deleted after you clear ARP entries.

Procedure

  • Run reset arp { all | dynamic ip ip-address [ vpn-instance vpn-instance-name ] | interface interface-type interface-number [ ip ip-address ] | slot slot-id }

    The ARP entries have been cleared.

  • Run reset arp packet statistics [ slot slot-id ]

    The ARP statistics of a specified or all boards have been cleared.

  • Run reset arp packet statistics interface [ interface-type interface-number ]

    The ARP statistics of a specified or all Layer 3 interfaces have been cleared.

  • Run reset arp packet statistics bridge-domain bd-id

    The ARP statistics of a specified BD have been cleared.

Monitoring the ARP Operating Status

This section describes how to monitor the ARP operating status.

Procedure

  • Run the display arp all command in any view to check ARP entries on all boards.
  • Run the display arp interface interface-type interface-number command in any view to check the ARP status on a specified interface.
  • Run the display arp slot slot-id command in any view to check the ARP status on the board in a specified slot.
  • Run the display arp packet statistics [ slot slot-id | interface [ interface-type interface-number ] ] command in any view to check ARP packet statistics.
Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055376

Views: 15704

Downloads: 33

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next