No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - LAN Access and MAN Access 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - LAN Access and MAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining QinQ

Maintaining QinQ

This section describes how to clear statistics about QinQ packets and monitor the QinQ operating status.

Clearing QinQ Statistics

Clear existing QinQ packet statistics before you are able to collect statistics about QinQ packets for a specific period of time.

Context

Statistics about QinQ packets cannot be restored after they are cleared. Exercise caution before you decide to clear the statistics.

To clear QinQ packet statistics, run the following command in the user view:

Procedure

  1. Run the reset qinq statistics interface interface-type interface-number.subinterface-number vlan-group group-id command to clear statistics about QinQ packets on the specified interface.

Monitoring the QinQ Operating Status

This section describes how to monitor the QinQ operating status.

Context

In routine maintenance, you can run the commands in any view to view the QinQ operating status.

Procedure

  1. Run the display qinq statistics [ interface interface-type interface-number .subinterface-number [ vlan-group group-id | vid vid [ ce-vid ce-vid ] ] ] [ verbose ] command to view QinQ packet statistics.

    The statistic enable (VLAN group view) command must be run in the VLAN group view to enable the function of collecting QinQ packet statistics based on VLAN groups before you run the display qinq statistics command to view the number of QinQ packets sent or received by the sub-interface. These statistics help you deploy QoS policies or locate problems. If the function of collecting QinQ packet statistics is disabled, you cannot view the statistics on the sub-interface.

  2. Run the display vlan-group [ group-id ] interface interface-type interface-number [ .subinterface-number ] command to view the number of VLAN groups and the configurations of each VLAN group on the specified interface.
Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055378

Views: 16836

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next