No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - LAN Access and MAN Access 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - LAN Access and MAN Access
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the MSTP Protocol Packet Format on an Interface

Configuring the MSTP Protocol Packet Format on an Interface

MSTP protocol packets can be transmitted in auto, dot1s, or legacy mode. The default mode is auto.

Context

MSTP protocol packets have two formats: dot1s (IEEE 802.1s standard packets) and legacy (proprietary protocol packets). The auto mode is introduced to allow an interface to automatically use the format of MSTP protocol packets sent from the remote interface. In this manner, the two interfaces use the same MSTP protocol packet format.

Do as follows on a switching device in a Multiple Spanning Tree (MST) region:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the Ethernet interface participating in STP calculation is displayed.

    NOTE:
    The following configurations can be configured both on a Layer 2 interface and a Layer 3 interface.

  3. (Optional) Run stp binding process process-id

    The interface is bound to an MSTP process.

    NOTE:

    This step binds an interface to an MSTP process with a non-zero ID. If the interface belongs to process 0, skip this step.

  4. Run stp compliance { auto | dot1s | legacy }

    The MSTP protocol packet format is configured on the interface.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055378

Views: 16368

Downloads: 34

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next