No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - Security 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - Security
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining URPF

Maintaining URPF

Before you start collecting statistics about URPF, clear the existing statistics.

Procedure

  1. Run the reset { ip | ipv6 } urpf discard statistics interface { interface-type interface-number | all } command to clear the statistics on the packets that fail the URPF check and are discarded on an interface.
  2. Run the reset { ip | ipv6 } urpf discard statistics [ slot slot-id ] command to the statistics on the packets that fail the URPF check and are discarded on an interface board.
Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055397

Views: 19849

Downloads: 39

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next