No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - Security 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - Security
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Layer 3 Loop Detection

Configuring Layer 3 Loop Detection

Layer 3 loop detection reports traps when detecting a routing loop so that you can take rapid measures to ensure proper service running.

Usage Scenario

The Layer 3 loop detection function detects whether a loop exists on a network. If a routing loop is detected, the device generates reports a trap.

Perform the following operations when no routing loop trap information is required.

NOTE:

To ensure network reliability, exercise caution when running the l3-loop-detect disable command.

This feature is supported only on the Admin-VS.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run l3-loop-detect disable

    Layer 3 loop detection is disabled.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055397

Views: 19662

Downloads: 39

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next