No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - Security 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - Security
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring DHCP Binding Table Update

Configuring DHCP Binding Table Update

The Dynamic Host Configuration Protocol (DHCP) binding table update function contains the client online status detection function and the DHCP snooping binding entry deletion function.

Usage Scenario

  • If a client obtains an IP address and goes offline abnormally, the client cannot release the IP address by sending a DHCP release packet. To resolve this problem, you can configure client online status detection. After client online status detection is enabled, the system uses Address Resolution Protocol (ARP) to detect a client periodically. If the system cannot detect the client for specified times, the system will delete the DHCP snooping binding entry for the client. The system also sends a release packet to the DHCP server to release the client's IP address.
    NOTE:
    This function can only be deployed on Layer 3 devices.
  • A DHCP snooping binding entry can be deleted manually if required. You can configure to send a release packet to the DHCP server to release the client's IP address.

This function dynamically maintains the DHCP snooping binding table. You can delete DHCP snooping binding entries based on virtual local area networks (VLANs), interfaces, or IP addresses.

Procedure

  • Configure client online status detection.
    1. Run system-view

      The system view is displayed.

    2. Run arp dhcp-snooping-detect enable

      Client online status detection is enabled.

    3. Run commit

      The configuration is committed.

  • Configure dynamic DHCP snooping binding entry deletion.
    1. Run system-view

      The system view is displayed.

    1. Run reset dhcp snooping bind-table [ vlan vlan-id [ interface interface-type interface-number ] | bridge-domain bd-id | interface interface-type interface-number | vpn-instance vpn-instance-name | public-net | ip-address ip-address [ interface interface-type interface-number ] | vsi vsi-name ] [ release ]

      The dynamic DHCP snooping binding entry is deleted.

      Using the release parameter, you can configure to send a release packet to the DHCP server to release the client's IP address.

  • Configure static DHCP snooping binding entry deletion.
    1. Run system-view

      The system view is displayed.

    1. Run undo dhcp snooping bind-table static [ vlan vlan-id [ interface interface-type interface-number ] | interface interface-type interface-number | vsi vsi-name | ip-address ip-address | bridge-domain bd-id ]

      The static DHCP snooping binding entry is deleted.

    1. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055397

Views: 19851

Downloads: 39

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next