No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring KOD

Configuring KOD

This section describes how to configure Kiss-o'-Death (KOD) feature and its operation in different modes.

Usage Scenario

NTP has the following operation modes:

  • Client/server mode

  • Peer mode

  • Multicast mode

  • Manycast mode

KOD is inapplicable to broadcast and multicast mode.


KOD is applicable only to NTP version 4.

Pre-configuration Tasks

Before configuring NTP KOD, complete the following tasks:

  • Configure the link layer protocol for the interface.

  • Configuring the network layer address and routing protocol to make the server and client reachable

Updated: 2019-01-02

Document ID: EDOC1100055400

Views: 26677

Downloads: 36

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next