No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Event Management

Configuring Event Management

This section describes how to configure event management to enable delayed event reporting.

Usage Scenario

You can configure event management to manage events and enable delayed event reporting.

Pre-configuration Tasks

Before configuring event management, complete the following tasks:

  • Power on the device and perform a device self-check.

Configuration Procedures

You can choose to undertake the following configuration tasks (except for checking the configurations) based on the usage scenario.

Configuring Delayed Event Reporting

To control the event reporting frequency, you can enable delayed event reporting by specifying a delay.

Context

If an event is repeatedly reported, you can enable delayed event reporting to prevent a large number of invalid events from being reported to the NMS.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run event

    The event view is displayed.

  3. Run delay-suppression enable

    Delayed event reporting is enabled.

  4. Run suppression event-name event-name period seconds

    A delay after which a generated event is reported is configured.

Verifying the Event Management Configuration

After configuring event management, verify the configuration.

Prerequisites

All event management configurations have been completed.

Procedure

  • Run the display event information [ name event-name ] command to check the registration information about a specified event or all events in the system.

Example

Run the display event information [ name event-name ] command to check the registration information about a specified event or all events in the system.

<HUAWEI> display event information name BD_ARPTRAP
-----------------------------------------------------------------------------
Feature    : MSTP
EventId    : 0xD540011
EventName  : BD_ARPTRAP
EventLevel : warning
TrapName        : hwBdArpNomatchSnpBindTblPktAlarm
Suppress Period : 3
-----------------------------------------------------------------------------
Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055400

Views: 20608

Downloads: 30

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next