No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Client/Server Mode

(Optional) Configuring the Client/Server Mode

In client/server mode, the clock on the client synchronizes with the master clock on the server.

Procedure

  • Configure the NTP client.
    1. Run system-view

      The system view is displayed.

    2. (Optional) Run ntp-service [ ipv6 ] source-interface interface-type interface-number [ vpn-instance vpn-instance-name ]

      The source interface for sending NTP packets is specified.

    3. Configure an IP address for the NTP server.

      • Run ntp-service unicast-server ip-address [ version number | authentication-keyid key-id | source-interface interface-type interface-number | vpn-instance vpn-instance-name | preference | maxpoll max-number | minpoll min-number | burst | iburst | preempt | port port-number] *

        The NTP server IPv4 address is configured.

      • Run ntp unicast-server ipv6 ipv6-address [ authentication-keyid key-id | source-interface interface-type interface-number | vpn-instance vpn-instance-name | preference | maxpoll max-number | minpoll min-number | burst | iburst | preempt | port port-number ] *

        The NTP server IPv6 address is configured.

      ip-address is the NTP server IP address. It can be a host address, but not the IP address of the reference clock. If a source interface to send NTP packets is specified on the server, the server IP address specified on the client must be this specified source interface address. Otherwise, the client cannot process NTP packets sent from the server and clock synchronization fails.

      If step 2 is performed, and source-interface is configured in step 3, the source interface specified in step 3 is preferred.

      NOTE:

      When the unicast NTP server is specified, the local router functions as the client automatically. No additional configurations are required on the server except the NTP master clock.

    4. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055400

Views: 14334

Downloads: 26

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next