No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Time Range-based Power Function

(Optional) Configuring the Time Range-based Power Function


If PDs only need to be powered within a certain time range, you can configure the time range-based power function. This allows a device to stop powering the PDs after the time range elapses, therefore conserving energy.


  1. Run system-view

    The system view is displayed.

  2. Run time-range time-range-name { start-time to end-time days | from time1 date1 [ to time2 date2 ] }

    A time range during which the NE20E equipment powers off the PD is configured.

  3. Run interface interface-type interface-number

    The interface view is displayed.

  4. Run poe power-off time-range time-range-name

    The interconnected PD is powered off after the time range elapses.

    To ensure around-the-clock power supply to the PD, run the undo poe power-off time-range command to disable the function of powering off a PD within a certain time range.

Updated: 2019-01-02

Document ID: EDOC1100055400

Views: 20548

Downloads: 30

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next