No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring NTP Authentication in Unicast Server/Client Mode

(Optional) Configuring NTP Authentication in Unicast Server/Client Mode

By configuring the authentication key ID used in the synchronization with the specific NTP server on the NTP client, you can apply NTP authentication in client/server mode. Perform the following steps on the NTP unicast client.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Configure a key ID for synchronization with a specified NTP server.

    • To specify an IP address for the NTP server, run the ntp-service unicast-server ip-address [ version number | authentication-keyid key-id | source-interface interface-type interface-number | vpn-instance vpn-instance-name | preference | maxpoll max-number | minpoll min-number | burst | iburst | preempt ] * command.
    • To specify an IPv6 address for the NTP server, run the ntp-service unicast-server ipv6 ipv6-address [ authentication-keyid key-id | source-interface interface-type interface-number | vpn-instance vpn-instance-name | preference | maxpoll max-number | minpoll min-number | burst | iburst | preempt | port port-number ] * command.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055400

Views: 19744

Downloads: 30

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next