No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring KOD on a Server

Configuring KOD on a Server

Procedure

  • Configure a router to send KOD packets.
    1. Run system-view

      The system view is displayed.

    2. Run ntp-service kod-enable

      KOD is enabled.

    3. Run ntp-service access { peer | query | server | synchronization | limited } { { acl-number | acl-name acl-name } | ipv6 { acl6-number | acl6-name acl6-name } } *

      Access control authority is set.

    4. Run ntp-service discard { min-interval min-interval-val | avg-interval avg-interval-val } *

      The minimum and average interval is configured for inter-packet spacing check.

    5. Run ntp-service refclock-master [ ip-address ] [ stratum ]

      The local clock is configured to be the NTP master clock that provides the synchronizing time for other devices.

    6. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055400

Views: 14653

Downloads: 26

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next