No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining VSs

Maintaining VSs

This section describes how to reset a VS when a VS needs to be upgraded or the diagnostics system is abnormal.

Resetting a VS

When updating VS configurations or diagnosing faults, you can reset the VS.



During resetting a VS, all interfaces of the VS switch to the Down state, and all services are interrupted. Exercise caution when running reset command. For details on precautions of this command, see reset virtual-system.

This configuration process is supported only on the Admin-VS.


  1. Run the reset virtual-system to reset a VS.
Updated: 2019-01-02

Document ID: EDOC1100055400

Views: 20410

Downloads: 30

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next