No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE20E-S2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Multi-level Alarm Boolean Output

Configuring the Multi-level Alarm Boolean Output

This section describes how to configure multi-level alarm Boolean output using the maintenance assistant.

Context

When the router is connected to an external alarm device through the ALMO port on the specific subcard, you can configure multi-level alarm Boolean output. In this way, when the router generates an alarm, it outputs the alarm to the alarm device through the ALMO port on the specific subcard.

This configuration task is supported only on the Admin-VS.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ops

    The OPS view is displayed.

  3. Run enable

    OPS is enabled.

  4. Run assistant task-name

    A maintenance assistant is created.

  5. Set conditions to trigger the maintenance assistant.

    • Run condition alarm level compare-operator level-name

      An alarm severity is specified.

    • Run condition timer cron minutes hours days-of-month months days-of-week [ years ]

      A timer is set for executing the maintenance assistant.

  6. Run execute priority command command-string

    The command used to execute the maintenance assistant is configured.

    For multi-level alarm Boolean output, set command-string to output-alarm slot slot-id index index-num level compare-operator level-name to enable a ALMO port on the specific subcard to output alarms of a specified severity.

  7. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055400

Views: 16134

Downloads: 26

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next