No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S2 V800R010C10SPC500 Feature Description - NAT and IPv6 Transition 01

This is NE20E-S2 V800R010C10SPC500 Feature Description - NAT and IPv6 Transition
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MAP-T/MAP-E Packet Processing

MAP-T/MAP-E Packet Processing

IPv6 single-stack is deployed on networks within a MAP domain. Service traffic sent by IPv6 terminals is carried over native IPv6.

To carry service traffic of IPv4 terminals, an IPv6 tunnel is established between a MAP-CE and a MAP-BR or between MAP-CEs. IPv4 packets can be encapsulated in either MPA-E or MAP-T mode:
  • MAP-T: a translation mode that translates an IPv4 header into an IPv6 header. Packets contain only an IPv6 header.
  • MAP-E: an encapsulation mode that adds an IPv6 header into each IPv4 packet. The IPv6 header is outer, and the IPv4 header is inner.
Figure 3-2 Basic MAP-T/MAP-E architecture

MAP-T data processing

Figure 3-3 MAP-T Data Processing Flowchart

MAP-E data processing

Figure 3-4 MAP-E Data Processing Flowchart
Updated: 2019-01-02

Document ID: EDOC1100055472

Views: 2622

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next