No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Feature Description - Network Reliability 01

This is NE20E-S2 V800R010C10SPC500 Feature Description - Network Reliability
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Ethernet OAM Applications on a MAN

Ethernet OAM Applications on a MAN

EFM, CFM, and Y.1731 can be combined to provide E2E Ethernet OAM solutions, implementing E2E Ethernet service management.

Figure 6-41 Ethernet OAM applications on a MAN

Figure 6-41 shows a typical MAN network. The following example illustrates Ethernet OAM applications on a MAN.
  • EFM is used to monitor P2P direct links between a digital subscriber line access multiplexer (DSLAM) and a user-end provider edge (UPE) or between a LAN switch (LSW) and a UPE. If EFM detects errored frames, codes, or frame seconds, it sends alarms to the network management system (NMS) to provide information for a network administrator. EFM uses the loopback function to assess link quality.

  • CFM is used to monitor E2E links between a UPE and an NPE or between a UPE and a provider edge-aggregation (PE-AGG). A network planning engineer groups the devices of each Internet service provider (ISP) into an MD and maps a type of service to an MA. A network maintenance engineer enables maintenance points to exchange CCMs to monitor network connectivity. After receiving an alarm on the NMS, a network administrator can enable loopback to locate faults or enable linktrace to discover paths.

  • Y.1731 is used to measure packet loss and the delay on E2E links between a UPE and an NPE or between a UPE and a PE-AGG at the aggregation layer.

Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055473

Views: 13420

Downloads: 4

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next