No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S2 V800R010C10SPC500 Feature Description - Network Reliability 01

This is NE20E-S2 V800R010C10SPC500 Feature Description - Network Reliability
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Status Control

Status Control


VRRP is a fault-tolerant protocol defined in relevant standards . As shown in Figure 8-1, the routers on the LAN (Device1, Device2, and Device3) are arranged in a backup group using VRRP. This backup group functions as a virtual router.

Figure 8-1 Schematic diagram for a virtual router

On the LAN, hosts need to obtain only the IP address of the virtual router rather than the IP address of each router in the backup group. The hosts set the IP address of the virtual router as the address of their default gateway. Then, the hosts can communicate with an external network through the virtual gateway.

VRRP dynamically associates the virtual router with a physical router that transmits services. When the physical router fails, another router is selected to take over services and user services are not affected. The internal network and the external network can communicate without interruption.

Principles of the Active/Standby Switchover

During the implementation of high reliability of services, VRRP is responsible for the negotiation of the master and standby devices; BFD or Eth OAM is responsible for fast detection of link faults to perform a rapid active/standby switchover.

Figure 8-2 Diagram of the active/standby switchover for high reliability of services

As shown in Figure 8-2, the two routers negotiate the master and standby states using VRRP. The NE20E supports active/standby status selection of interfaces and sub-interfaces.

BFD is enabled between the two routers to detect links between the two devices. BFD in this mode is called Peer-BFD. BFD is also enabled between the router and the LSW to detect links between the router and the LSW. BFD in this mode is called Link-BFD.

When a link fails, through VRRP, the new master and standby devices can be negotiated, but several seconds are needed and the requirements of carrier-grade services cannot be met. Through BFD or Eth OAM, a faulty link can be detected in several milliseconds and the device can perform a fast active/standby switchover with the help of VRRP.

During the implementation of an active/standby switchover, VRRP has to determine device status based on Link-BFD status and Peer-BFD status. As shown in Figure 8-2, when Link 1 fails, the Peer-BFD status and Link-BFD status of Device1 both go down and Device1 becomes the standby device. In this case, the Peer-BFD status of Device2 goes down but the Link-BFD status of Device2 is still up. Therefore, Device2 becomes the master device.

In actual networking, certain LSWs may not support BFD. In this case, you have to select another detection mechanism. Besides BFD, the NE20E also supports detection of links connecting to LSWs through Eth OAM.

The NE20E supports monitoring of upstream links (for example, Link 3 in Figure 8-2) to enhance reliability protection for the network side. When an upstream link fails, the NE20E responds to the link failure quickly and performs an active/standby link switchover.

Updated: 2019-01-02

Document ID: EDOC1100055473

Views: 13091

Downloads: 4

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next