No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S2 V800R010C10SPC500 Feature Description - System Monitor 01

This is NE20E-S2 V800R010C10SPC500 Feature Description - System Monitor
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
NQA Detection on a Layer 2 Network

NQA Detection on a Layer 2 Network

MAC Ping Test

Function Overview

NQA MAC ping is an Ethernet OAM tool defined in IEEE 802.1ag. A MAC ping test is performed between a maintenance association end point (MEP) and a maintenance point (MP) to detect network connectivity between the two nodes. The test is initiated by the MEP and the destination node can be either a MEP or a MIP with the same level as the MEP, no matter whether the two nodes are in the same maintenance association (MA).

Test Process
Figure 4-20 Network for a MAC ping test

On the network shown in Figure 4-20, MEP1 on PE1 connects to two remote MEPs: MEP2 on PE2 and MEP3 on PE3. The process of the MAC ping test initiated by MEP1 to MEP2 is as follows:

  1. MEP1 sends a Loopback Message (LBM) to MEP2.

  2. Upon receipt, MEP2 responds with a Loopback Reply (LBR). Based on the LBR, the initiator can calculate the time used by the ping operation to analyze network performance.

    Within the specified timeout period:
    • If MEP1 does not receive the LBR returned by MEP2, MEP1 regards that the path between itself and MEP2 is unreachable.

    • If MEP1 receives the LBR from MEP2, MEP1 calculates the transmission delay between itself and MEP2 based on the timestamps carried in the LBR.

    During the test, the initiator can send multiple LBMs continuously and then observe returned LBRs. A MAC ping test can collect Ethernet OAM statistics, including average delay, jitter, and packet loss ratio based on the timestamps carried in packets. These statistics clearly reflect Ethernet performance.

Usage Scenario

MAC ping tests are used in scenarios where multiple MEPs are configured.

Benefits

The Ethernet OAM statistics collected during MAC ping tests, including average delay, jitter, and packet loss ratio, clearly reflect Ethernet performance.

Translation
Download
Updated: 2019-01-02

Document ID: EDOC1100055478

Views: 5244

Downloads: 2

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next