Setting Upgrade Parameters
Your endpoint supports automatic and manual upgrades. With the automatic upgrade function enabled, your endpoint obtains upgrade files from a specified server and installs the upgrade files when the upgrade interval arrives.
Procedure
- Choose .
The Installation page is displayed.
- Click Auto Upgrade Settings.
The Auto Upgrade Settings page is displayed.
- Set the upgrade parameters listed in Table 3-35.
Table 3-35 Upgrade parameters
Parameter
Description
Setting
Auto upgrade
Specifies whether the automatic upgrade function is enabled. If you set this parameter to Enable, you must also set Upgrade interval, Server address, User name, and Password. Your endpoint will obtain upgrade files from the specified server and install the files when the specified upgrade interval is reached.
This parameter is deselected by default.
Enable wireless MIC auto update
Specifies whether to automatically update an upgradable wireless microphone VPM220W after it is connected to the endpoint.
This parameter is selected by default.
Upgrade interval
Specifies the upgrade interval. This parameter is available only when Auto upgrade is selected.
The default value is 0.5 h.
Value range: 0.5 h to 24 h
Server address
Specifies the IP address of the server that stores the upgrade files for your endpoint.
This parameter cannot be left blank.
User name
Password
Specify the user name and password your endpoint uses to access the server.
No default value is set for these parameters.
- Perform either of the following:
- If you selected Auto upgrade, click Save.
- Click Manual upgrade.