Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Switching Between Audio-only and Video Calls
When your endpoint sets up a SIP point-to-point call with a SIP site or Lync client, you can switch the call between audio-only and video modes.
Background
Procedure
- Choose .
The Switch Between Audio and Video dialog box is displayed.
- Perform either of the following:
- During an audio-only call:Click Turn On Video to send a video request.
Before the remote site accepts the request, you can click Cancel Video Request to cancel the request.
- During a video call:
- Click Turn Off Video to turn off both local and remote video and switch to an audio-only call.
- Click Hold to hide local video from the remote site.
To display the video of your site at the remote site again, click Cancel Hold.
- During an audio-only call:
When the Video request handling parameter described in Setting Server Parameters is set to Manual on your endpoint, you can manually accept or reject a video request from a remote site. If you do not acknowledge the request within 20 seconds, the request dialog box automatically exits.