No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - Interface and Data Link 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - Interface and Data Link
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Interface Group

Configuring an Interface Group

An interface group can be used to perform interface configuration in batches, simplifying interface configurations and reducing management costs.

Context

Interface groups are classified into permanent and temporary interface groups. Multiple interfaces can be added to the same permanent or temporary interface group to enable batch command configurations for the interfaces. The differences between permanent and temporary interface groups are described as follows:
  • After a user exits the view of a temporary interface group, the system automatically deletes the temporary interface group. A permanent interface group, however, can be deleted only by using the undo port-group command.
  • Information about a permanent interface group can be viewed using the display port-group command, whereas information about a temporary interface group cannot.
  • After a permanent interface group is configured, a configuration file is generated. However, no configuration file is generated after a temporary interface group is configured.

Procedure

  • Configure a permanent interface group.
    1. Run system-view

      The system view is displayed.

    2. Run port-group port-group-name

      A permanent interface group is created and the view of the permanent interface group is displayed.

    3. Run group-member { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10>

      Specified interfaces are added to the permanent interface group.

    4. Run commit

      The configuration is committed.

  • Configure a temporary interface group.
    1. Run system-view

      The system view is displayed.

    2. Run port-group group-member { interface-type-start interface-number-start [ to interface-type-end interface-number-end ] } &<1-10>

      A temporary interface group is created and specified interfaces are added to the temporary interface group.

Checking the Configuration

After the configuration is complete, run the display port-group [ all | port-group-name ] command to view information about a specified permanent interface group or all permanent interface groups.

Run the display port-group all command to view information about all permanent interface groups.

<HUAWEI> display port-group all
 Port-group: port-group1                      Total group-members: 2
 Members                             AdminState
 GigabitEthernet0/3/0                up
 GigabitEthernet0/3/1                up

 Port-group: port-group2                      Total group-members: 2
 Members                             AdminState
 GigabitEthernet0/1/8                up
 GigabitEthernet0/1/9                up
Download
Updated: 2019-01-02

Document ID: EDOC1100058380

Views: 1811

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next