No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - Interface and Data Link 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - Interface and Data Link
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Managing Interfaces

Example for Managing Interfaces

This section uses an example to describe how to configure interface parameters, such as the interface description, maximum transmission unit (MTU), and interval at which traffic statistics are collected.

Networking Requirements

To ensure smooth communication between devices on a network, you need to configure both physical and logical interfaces properly and set the following parameters:
  • Interface description
  • MTU
  • Trap threshold for the outbound and inbound bandwidth usage on a specified interface
  • Interval at which traffic statistics are collected
  • Whether the device sends a trap message to the network management system (NMS) when the interface status changes
  • Whether the control-flap function is enabled

Configuration Roadmap

The configuration roadmap is as follows:

  1. Configure description for an interface.

  2. Set an MTU for the interface to ensure successful packet transmission over the interface.

  3. Set the interval at which traffic statistics (including the traffic volumes and rates) are collected globally.

  4. Create a sub-interface and set an MTU for the sub-interface so that packets can reach the receiver.

Data Preparation

To complete the configuration, you need the following data:

  • Interface name

  • Interface description

  • Interface MTU

  • Interval at which traffic statistics are collected globally

  • Sub-interface MTU

Procedure

  1. Configure description for an interface.

    <HUAWEI> system-view
    [*HUAWEI] interface gigabitethernet 0/2/0
    [*HUAWEI-GigabitEthernet0/2/0] description for IFM
    [*HUAWEI-GigabitEthernet0/2/0] commit

  2. Set an MTU for the interface.

    [*HUAWEI-GigabitEthernet0/2/0] mtu 1000
    [*HUAWEI-GigabitEthernet0/2/0] commit
    [*HUAWEI-GigabitEthernet20/2/0] quit

  3. Set the interval at which traffic statistics are collected globally.

    [*HUAWEI] set flow-stat interval 100
    [*HUAWEI] commit

  4. Create a sub-interface and set the MTU of the sub-interface.

    [*HUAWEI] interface gigabitethernet 0/2/0.1
    [*HUAWEI-GigabitEthernet0/2/0.1] mtu 800
    [*HUAWEI-GigabitEthernet0/2/0.1] commit

Configuration Files

#
sysname HUAWEI
#
set flow-stat interval 100
#
interface gigabitethernet0/2/0
 description for IFM
 mtu 1000
#
interface gigabitethernet0/2/0.1
 mtu 800
#
return
Download
Updated: 2019-01-02

Document ID: EDOC1100058380

Views: 1849

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next