No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Manycast Mode

(Optional) Configuring the Manycast Mode

The NTP manycast mode can be configured to synchronize clocks in a manycast domain.

Procedure

  • Configure an NTP manycast server.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The view of the interface sending NTP multicast messages is displayed.

    3. Configure an NTP manycast server.

      • Run ntp-service manycast-server ip-address

        The Router is configured as an NTP manycast server on an IPv4 network.

      • Run ntp-service manycast-server ipv6 [ ipv6-address ]

        The Router is configured as an NTP manycast server on an IPv6 network.

  • Configure an NTP manycast client.

    Perform the following steps on the Router functioning as an NTP manycast client:

    1. Run system-view

      The system view is displayed.

    2. (Optional) Run ntp-service max-dynamic-sessions number

      The number of dynamic sessions allowed to be set up is set.

      Running the ntp-service max-dynamic-sessions command does not affect the existing NTP sessions. When the number of sessions reaches the maximum number, no more sessions can be set up.

    3. Run interface interface-type interface-number

      The interface to receive manycast NTP packets is specified.

    4. Run:

      • ntp-service manycast-client ip-address [ [ authentication-keyid key-id ] | ttl ttl-number | port port-number ] *

        The device is configured as an NTP manycast client on an IPv4 network.

      • ntp-service manycast-client ipv6 [ ipv6-address ][ [ authentication-keyid key-id ] | ttl ttl-number | port port-number ] *

        The device is configured as an NTP manycast client on an IPv6 network.

    5. Run commit

      The configuration is committed.

      The NTP manycast client listens to the manycast NTP packets sent from the server and synchronizes the local clock.

Download
Updated: 2019-01-02

Document ID: EDOC1100058392

Views: 18390

Downloads: 31

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next