No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Creating VSs

Example for Creating VSs

This section provides an example for creating VSs and allocate resources to the VSs.

Networking Requirements

NOTE:
This configuration example is supported only on the Admin-VS.

On the network shown in Figure 2-4, the IPU of a PS processes all services offered by an SP. If a service failure on the PS causes a PS failure, other services running on the PS cannot be properly forwarded. To prevent this problem, configure different VSs on the PS to independently carry services to improve network security.

Figure 2-4 Creating VSs

Precautions

When creating VSs, note the following points:
  • A VS starts after it is created.
  • The VS slot resources can be allocated only by the PS administrator.
  • The same slot resources can be allocated to multiple VSs.
  • An interface can be allocated only to a single VS.
  • The slot resources deleted from a VS are automatically allocated to the Admin-VS, and the Admin-VS takes over services carried using these slot resources.

Configuration Roadmap

The configuration roadmap is as follows:

  1. Create VSs and configure PVMBs for each VS so that the VSs can start.

  2. Allocate interfaces to VSs to allow the VSs to forward services.

Data Preparation

To complete the configuration, you need the following data:

  • Names of the VSs to be created: vs1, vs2, and vs3
  • Interface number allocated to each VS

Procedure

  1. Create and start VSs.

    <HUAWEI> system-view
    [~HUAWEI] admin
    [*HUAWEI-admin] virtual-system vs1
    [*HUAWEI-admin-vs:vs1] port-mode port
    [*HUAWEI-admin-vs:vs1] description vs1
    [*HUAWEI-admin-vs:vs1] quit
    [*HUAWEI-admin-vs:vs2] virtual-system vs2
    [*HUAWEI-admin-vs:vs2] port-mode port
    [*HUAWEI-admin-vs:vs2] description vs2
    [*HUAWEI-admin-vs:vs2] quit
    [*HUAWEI-admin-vs:vs3] virtual-system vs3
    [*HUAWEI-admin-vs:vs3] port-mode port
    [*HUAWEI-admin-vs:vs3] description vs3
    [*HUAWEI-admin-vs:vs3] quit
    [*HUAWEI-admin] commit
    

  2. Allocate resources to the VSs.

    [~HUAWEI-admin] virtual-system vs1
    [*HUAWEI-admin-vs:vs1] assign interface gigabitethernet 0/3/2
    [*HUAWEI-admin-vs:vs1] quit
    [~HUAWEI-admin] virtual-system vs2
    [*HUAWEI-admin-vs:vs2] assign interface gigabitethernet 0/3/3
    [*HUAWEI-admin-vs:vs2] quit
    [~HUAWEI-admin] virtual-system vs3
    [*HUAWEI-admin-vs:vs3] assign interface gigabitethernet 0/3/4
    [*HUAWEI-admin] commit

  3. Configure different services or features on the VSs.

    For configuration details, see the related feature configurations. For example, to configure a routing protocol on VS1, see the chapter "IP Routing" in the NE40E Configuration Guide - IP Routing.

  4. Verify the configuration.

    Run the display virtual-system command on the PS. The command output shows that vs1, vs2, and vs3 have been created and started.

    [*HUAWEI-admin] display virtual-system
    ---------------------------------------------------------------
    Name                             Status         Description
    ---------------------------------------------------------------
    Admin-VS                         running         admin-vs
    vs1                              running         vs1
    vs2                              running         vs2
    vs3                              running         vs3
    ---------------------------------------------------------------  

    Run the display virtual-system [ name vs-name ] [ verbose ] command on the PS. The following example uses vs1 configurations.

    [~HUAWEI-admin] display virtual-system name vs1
    Name         : vs1
    Status       : running
    Description  :
    Create time  : 2017-03-13 21:24:27+09:30 DST
    Port mode    : port
    System MAC   : 380b-0111-1207
    Assigned slot(s)
    pvmb         : 6
    pvmb         : 7
    CPU(s)
    slot 6      : 4%
    slot 7      : 4%
    fcard:/VS_huawei: 0%, 16/41943040 (Used Kbytes/Max Kbytes)
    Assigned interface(s)
      GE3/0/0, slot 3
    Assigned resource(s)
    u4route      : 10000(Max)
    m4route      : 1000(Max)
    u6route      : 1000(Max)
    m6route      : 1000(Max)
    vpn-instance : 256(Max)
    cpu          : 5(weight)
    
    Run the display virtual-system configuration state command on the PS to check whether VS configurations have been saved.
    [~HUAWEI-admin] display virtual-system configuration state
    -----------------------------------------------------------------
    Name                             Saved-configuration             
    -----------------------------------------------------------------
    Admin-VS                         not saved                       
    vs1                              not saved                       
    vs2                              not saved                       
    vs3                              not saved                       
    -----------------------------------------------------------------

Configuration Files

PS configuration files

#
admin
 virtual-system vs1
  assign interface GigabitEthernet0/3/2
 virtual-system vs2
  assign interface GigabitEthernet0/3/3
 virtual-system vs3
  assign interface GigabitEthernet0/3/4
Download
Updated: 2019-01-02

Document ID: EDOC1100058392

Views: 19948

Downloads: 33

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next