No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for Device Management--M2H

Licensing Requirements and Limitations for Device Management--M2H

Licensing Requirements

BOM

License Control Item

Description

Minimum Version Requirement

82401018

50GE Bandwidth Expansion License

Controllable feature:

By default, only the first 50GE port is enabled on the 2*50GE board. This license is used to enable the second 50GE port, or to enable the first port to be 100GE, so that the bandwidth can be smoothly upgraded to 100GE. If the service function license is not purchased, the corresponding function cannot be used.

V800R010C00

Restrictions and Guidelines

Restrictions

Guidelines

Impact

Boards cannot be reseated, power-cycled, or reset during the upgrade of board firmware.

  • The system displays a message if a board is power-cycled or reset during the upgrade of board firmware.
  • No workarounds are available for the scenario where boards are reseated.

The board is damaged, asking users to perform an upgrade through commands or return the board for repair.

Only one user is allowed to run an upgrade command at the same time.

The system displays a message if another upgrade command is delivered during the upgrade of board firmware.

None

The device does not support the switchover between the router mode and PTN mode.

To use the PTN mode, replace the current device with one that supports the PTN mode.

The switchover between the router mode and PTN mode using the active mode-control license command or its undo form is affected.

Download
Updated: 2019-01-02

Document ID: EDOC1100058392

Views: 19910

Downloads: 33

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next