No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling and Disabling the PADS

Enabling and Disabling the PADS

This section describes how to set the PADS function status when the PADS is used.

Context

NOTE:

This configuration process is supported only on the Admin-VS.

The protocol-aided diagnosis system (PADS) is an intelligent diagnosis system. It simulates service experts to be online for 7 x 24 hours and to implement automatic service fault prevention, discovery, and diagnosis from end to end. The PADS also supports automatic fault recovery with the help of the self-healing system. By default, the function is enabled. To disable the PADS function, perform the following steps.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Choose either of the following methods to disable the PADS function.

    • To disable the PADS function globally, run the pads disable command.

    • To disable the PADS function of a specific feature, run the pads switch { te-lsp-flap | isis-neighbor-flap | bgp-health | bgp-neighbor-flap | bgp-route-trace | fes-health | isis-route-conflict | memory-leak | multicast-route-diagnose | ospf-neighbor-flap | ospf-route-conflict | stack-health | ssh-interaction | snmp-interaction | rm-health | cpu-diagnose | isis-health | nca-failed-operation | te-health | ldp-health | multicast-health | board-unregistered | card-unregistered } disable command.

    NOTE:

    If the pads switch command is not run, the status of functions in the protocol-aided diagnosis system is determined by the pads disable command. If the pads switch command is run, the status of a specific function in the protocol-aided diagnosis system is determined by the pads switch command no matter the status of the entire protocol-aided diagnosis system is enabled or disabled.

  3. Run commit

    The configuration is committed.

Download
Updated: 2019-01-02

Document ID: EDOC1100058392

Views: 16487

Downloads: 26

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next