No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Configuring a Device to Communicate with an NMS by Using SNMPv2c

Example for Configuring a Device to Communicate with an NMS by Using SNMPv2c

This section provides an example to describe how to configure a device to communicate with an NMS by using SNMPv2c and how to specify the MIB objects that can be managed by the NMS.

Networking Requirements

As shown in Figure 16-13, two NMSs (NMS1 and NMS2) and the Router are connected across a public network. According to the network planning, NMS2 can manage every MIB object on the Router, and NMS1 does not manage the Router.

On the Router, only the modules that are enabled by default are allowed to send alarms to NMS2. This prevents an excess of unwanted alarms from being sent to NMS2. Excessive alarms make fault location difficult. Inform messages need to be used to ensure that alarms are received by NMS2 because alarms sent by the Router have to travel across the public network to reach NMS2.

Contact information of the device administrator needs to be configured on the Router. This helps the NMS administrator contact the device administrator if a fault occurs.

Figure 16-13 Networking diagram for configuring a device to communicate with an NMS by using SNMPv2c

NOTE:

Interface 1 in this example is GE 0/1/0.

Configuration Roadmap

The configuration roadmap is as follows:

  1. Enable the SNMP agent.

  2. Configure the Router to run SNMPv2c.

  3. Configure an ACL to allow NMS2 to manage every MIB object on the Router.

  4. Configure the Router to send Inform messages to NMS2 to ensure alarm sending reliability.

  5. Configure the contact information of the device administrator.

  6. Configure NMS2.

Data Preparation

To complete the configuration, you need the following data:

  • SNMP version

  • Community name

  • ACL number

  • IP address of the NMS

  • Contact information of the device administrator

Procedure

  1. Configure available routes between the Router and the NMSs. Details for the configuration procedure are not provided here.
  2. Enable the SNMP agent.

    <HUAWEI> system-view
    [~HUAWEI] sysname DeviceA
    [*HUAWEI] snmp-agent password min-length 10
    [*HUAWEI] snmp-agent
    [*HUAWEI] commit

  3. Configure the Router to run SNMPv2c.

    [~DeviceA] snmp-agent sys-info version v2c
    [*DeviceA] commit

    # Check the configured SNMP version.

    [~DeviceA] display snmp-agent sys-info version
    SNMP version running in the system:
               SNMPv2c SNMPv3

  4. Configure the NMSs access rights.

    # Configure an ACL to allow NMS2 to manage and disallow NMS1 from managing the Router.
    [~DeviceA] acl 2001
    [*DeviceA-acl4-basic-2001] rule 5 permit source 1.1.1.2 0.0.0.0
    [*DeviceA-acl4-basic-2001] rule 6 deny source 1.1.1.1 0.0.0.0
    [*DeviceA-acl4-basic-2001] commit
    [~DeviceA-acl4-basic-2001] quit

    # Configure a MIB view.

    [~DeviceA] snmp-agent mib-view excluded allexthgmp 1.3.6.1.4.1.2011.6.7
    [*DeviceA] commit

    # Configure a community name to allow NMS2 to manage the objects in the MIB view.

    [~DeviceA] snmp-agent community write adminnms2 mib-view allexthgmp acl 2001
    [*DeviceA] commit

  5. Configure the trap function.

    [~DeviceA] snmp-agent target-host inform address udp-domain 1.1.1.2 params securityname Huawei-1234 v2c
    [*DeviceA] snmp-agent inform timeout 5 resend-times 6 pending 7
    [*DeviceA] snmp-agent trap enable
    [*DeviceA] snmp-agent notification-log enable
    [*DeviceA] snmp-agent notification-log global-ageout 24
    [*DeviceA] commit

  6. Configure the contact information of the device administrator.

    [~DeviceA] snmp-agent sys-info contact call Operator at 010-12345678
    [*DeviceA] commit

  7. Configure NMS2.

    For details on how to configure NMS2, see the relevant NMS configuration guide.

  8. Verify the configuration.

    After the configuration is complete, run the following commands to verify that the configuration has taken effect.

    # Check the configured SNMP version.

    [~DeviceA] display snmp-agent sys-info version
    SNMP version running in the system:
               SNMPv2c SNMPv3

    # Check information about the SNMP community name.

    <DeviceA> display snmp-agent community
       Community name: %#%#qTp*MccD#Z[sHw4"pbzVHzAfO]gWN;h#30K=)%}X1jIHNF<QdMskYG$9xj:9k\EZN6Mi!Hrt@\Oa8tqP%#%#
           Group name: %#%#qTp*MccD#Z[sHw4"pbzVHzAfO]gWN;h#30K=)%}X1jIHNF<QdMskYG$9xj:9k\EZN6Mi!Hrt@\Oa8tqP%#%#
           Acl: 2001
           Storage-type: nonVolatile
    # Check the configured ACL.
    <DeviceA> display acl 2001
    Basic ACL 2001, 2 rules
    Acl's step is 5
     rule 5 permit source 1.1.1.2 0 (0 times matched)
     rule 6 deny source 1.1.1.1 0 (0 times matched)

    # Check the MIB view.

    <DeviceA> display snmp-agent mib-view viewname allexthgmp
    View name: allexthgmp
           MIB Subtree: huaweiUtility.7
           Subtree mask: FF80(Hex)
           Storage-type: nonVolatile
           View Type: excluded
           View status: active 
    

    # Check the target host.

    <DeviceA> display snmp-agent target-host
    Target-host NO. 1
    ---------------------------------------------------------------------------
      Host-name                        : -
      IP-address                       : 1.1.1.1
      Source interface                 : -
      VPN instance                     : -
      Security name                    : %#%#&NchK)p777^{b1BQtds=_<$O.<~qR.DDbwYS3_G6%#%#
      Port                             : 162
      Type                             : inform
      Version                          : v2c
      Level                            : No authentication and privacy
      NMS type                         : NMS
      With ext-vb                      : Yes
      Notification filter profile name : -
    ---------------------------------------------------------------------------

    # Check the contact information of the device administrator.

    <DeviceA> display snmp-agent sys-info contact
    The contact person for this managed node:
               call Operator at 010-12345678 

Configuration Files

  • Router configuration file

    #
     sysname DeviceA
    #
    acl number 2001
     rule 5 permit source 1.1.1.2 0.0.0.0
     rule 6 deny source 1.1.1.1 0.0.0.0
    #
    interface GigabitEthernet0/1/0
     undo shutdown
     ip address 1.1.2.1 255.255.255.0
    #
    ospf 1
     area 0.0.0.0
      network 1.1.2.0 0.0.0.255
    #
     snmp-agent
     snmp-agent password min-length 10
     snmp-agent local-engineid 800007DB03360102101100
     snmp-agent community write %#%#qTp*MccD#Z[sHw4"pbzVHzAfO]gWN;h#30K=)%}X1jIHNF<QdMskYG$9xj:9k\EZN6Mi!Hrt@\Oa8tqP%#%#
    xthgmp acl 2001
    #
     snmp-agent sys-info contact call Operator at 010-12345678
     snmp-agent sys-info version v2c v3
     snmp-agent target-host inform address udp-domain 1.1.1.2 params securityname cipher %#%#&NchK)p777^{b1BQtds=_<$O.<~qR.DDbwYS3_G6%#%# v2c
    #
     snmp-agent mib-view excluded allexthgmp hwCluster
    #
    snmp-agent inform timeout 5
    snmp-agent inform resend-times 6
    snmp-agent inform pending 7    
    snmp-agent notification-log enable
    snmp-agent notification-log global-ageout 24
    #
    return
Download
Updated: 2019-01-02

Document ID: EDOC1100058392

Views: 15025

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next