No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Activating an Interface-specific Basic Hardware License

Activating an Interface-specific Basic Hardware License

This section describes how to activate an interface-specific basic hardware license on a port for the port to use resource and function items controlled by the license.

Usage Scenario

For the CR5D0E5XMF90 subcard in 2*50G mode, only port 1 supports this command. Port 0 has the capacity of 50 Gbit/s bandwidth by default. When port 1 is not activated, the bandwidth of port 0 is limited to 100 Mbit/s. For the CR5D0E5XMF90 subcard in 1*100G mode, port 0 supports this command. When the license is not activated, the bandwidth of port 0 is limited to 50 Gbit/s. After the license is configured and activated, port 0 has the full capacity of 100 Gbit/s bandwidth.

This configuration task is supported only on the Admin-VS.

Pre-configuration Tasks

Before activating an interface-specific basic hardware license, complete the following task:

  • Run the license active command to load and activate the license authorization file.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run license

    The license view is displayed.

  3. Run active port-basic slot slot-id card card-id port port-listundo active port-basic slot slot-id card card-id [ port port-list ]

    The interface-specific basic hardware license is activated.

    In the license view, run:

    The interface-specific basic hardware license is deactivated. After the configuration is committed, the basic hardware license resources consuming the bandwidth of the interface are released.

  4. Run commit

    The configuration is committed.

    NOTE:

    The activate operation applies only to physical interfaces. If available interface-specific basic hardware license resources corresponding to interface bandwidth exist, the basic hardware function of the interface is automatically activated. If available interface-specific basic hardware license resources corresponding to interface bandwidth are insufficient, the interface enters the configuration-inactive state and generates an LCS_1.3.6.1.4.1.2011.5.25.142.2.28 hwGtlResourceLack alarm.

Checking the Configurations

After activating the interface-specific basic hardware license, check the configurations.

Run the display license resource usage port-basic all command in any view to check the license activation status of all interfaces supporting interface-specific basic hardware licenses.

Download
Updated: 2019-01-02

Document ID: EDOC1100058392

Views: 15125

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next