No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - System Management
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring NTP Authentication in Manycast Mode

(Optional) Configuring NTP Authentication in Manycast Mode

By configuring the authentication key ID used in the synchronization with the NTP manycast client on the local Router, you can apply NTP authentication in manycast mode.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ntp-service manycast-client [ ip-address | ipv6 [ ipv6-address ] ] [ [ authentication-keyid key-id ] | ttl ttl-number | port port-number ] *

    The authentication key ID used by the NTP manycast client is configured.

  4. Run commit

    The configuration is committed.

Download
Updated: 2019-01-02

Document ID: EDOC1100058392

Views: 17816

Downloads: 28

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next