No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating a Synchronous Serial Interface on an E3 Interface

Creating a Synchronous Serial Interface on an E3 Interface

Before using an E3 interface to transmit data, you must create a synchronous serial interface on the E3 interface.

Context

Depending on the E3 interface working modes, you can create the following two types of synchronous serial interfaces on an E3 interface:

  • If the E3 interface works in clear channel mode, an unframed synchronous serial interface with a bandwidth of 34.368 Mbit/s is created.

  • If the E3 interface works in unchannelized mode, a synchronous serial interface with a bandwidth of 33.831 Mbit/s is created after you manually create a framed E3 channel.

By default, an E3 interface works in unchannelized mode.

This configuration process is supported only on the Admin-VS.

Procedure

  • Create a synchronous serial interface on an E3 interface working in clear channel mode.
    1. Run system-view

      The system view is displayed.

    2. Run controller e3 controller-number

      The specified E3 interface view is displayed.

    3. Run using e3

      The E3 interface is configured to work in clear channel mode, and an unframed synchronous serial interface with a bandwidth of 34.368 Mbit/s is created.

      After the synchronous serial interface is created, you can run the interface serial controller-number command to display the view of the synchronous serial interface.

    4. Run commit

      The configuration is committed.

  • Create a synchronous serial interface on an E3 interface working in unchannelized mode.
    1. Run system-view

      The system view is displayed.

    2. Run controller e3 controller-number

      The specified E3 interface view is displayed.

    3. Run using ce3

      The E3 interface is configured to work in unchannelized mode.

    4. Run e3 framed

      A framed E3 channel is created, and an unframed synchronous serial interface with a bandwidth of 33.831 Mbit/s is created.

      After the synchronous serial interface is created, you can run the interface serial controller-number command to display the view of the synchronous serial interface.

    5. Run commit

      The configuration is committed.

Download
Updated: 2019-01-02

Document ID: EDOC1100058399

Views: 17337

Downloads: 61

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next