No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configurations

Checking the Configurations

After configuring MC-LMSP, you can check the LMSP group's working mode, working interface, switchback time, and interface status.

Procedure

  1. Run the display aps group group-id command to check configurations of an LMSP group.
  2. Run the display cpos-trunk trunk-id command to check configurations of the CPOS-Trunk interfaces.

Example

After configuring MC-LMSP, run the display aps group group-id command on the Router where the protection interface is located to view configurations of the LMSP group.

<HUAWEI> display aps group 1
 APS Group  1: APS working channel is 1.1.1.12
               Cpos0/1/0 protection channel 0(Active)
               Unidirection, 1+1 mode, None Revert Mode
               KeepAlive Timer: 1(seconds), Hold Timer: 3(seconds)
               Local detect Signal Fail High priority on working side
--------------------------------------------------------------------------------
Group Work-Channel Protect-Channel Wtr W-State P-State Switch-Cmd Switch-Result
--------------------------------------------------------------------------------
1     1.1.1.12     Cpos0/1/0        NA   NA      ok     NA          switch
--------------------------------------------------------------------------------

After configuring MC-LMSP, run the display aps group group-id command on the Router where the working interface is located to view configurations of the LMSP group.

<HUAWEI> display aps group 1
 APS Group  1: Cpos0/1/1 working channel 1(Active)
               APS protection channel is 1.1.1.13
--------------------------------------------------------------------------------
Group Work-Channel Protect-Channel Wtr W-State P-State Switch-Cmd Switch-Result
--------------------------------------------------------------------------------
1     Cpos0/1/1   1.1.1.13         NA   ok      ok     NA          idle
--------------------------------------------------------------------------------
total entry: 1

Run the display cpos-trunk trunk-id command to view configurations of the trunk interface.

<HUAWEI> display cpos-trunk 1
Interface Cpos-Trunk1's state information is:
Operate status: up     Number Of Up Port In Trunk: 1
--------------------------------------------------------------------------------
PortName     Status     Active Status
Cpos0/1/0     Up         Active
Download
Updated: 2019-01-02

Document ID: EDOC1100058399

Views: 17569

Downloads: 61

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next