No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Frame Format for a CE1 Interface

Configuring the Frame Format for a CE1 Interface

You can configure a CE1 interface to use a 4-bit CRC code to check physical frames.


You can configure the frame format for a CE1 interface only when it works in channelized mode.


  1. Run system-view

    The system view is displayed.

  2. Run controller e1controller-number

    The CE1 interface view is displayed.

  3. Run frame-format { crc4 | no-crc4 }

    A frame format is configured for the CE1 interface.


    When setting the frame format of a CE1 interface, ensure that the local and remote ends are configured with the same frame format.

  4. Run commit

    The configuration is committed.

Updated: 2019-01-02

Document ID: EDOC1100058399

Views: 15127

Downloads: 39

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next