No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Link Layer Protocol for a Serial Interface

Configuring the Link Layer Protocol for a Serial Interface

This section describes how to configure a link-layer protocol for a serial interface. The link-layer protocol used by a serial interface determines the format of frames passing through this interface.Currently, the NE40E allows a serial interface to use PPP, TDM,, HDLC or ATM as the link-layer protocol.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface serial interface-number

    The serial interface view is displayed:

    • To enter the view of a serial interface on a CE1 interface, you must specify interface-number in the format of "chassis number/slot number/card number/port number:serial interface number". For example, the name of serial interface 1 on CE1 0/2/0 is serial 0/2/0:1.
    • To enter the view of a serial interface on a CPOS interface, you must specify interface-number in the format of "chassis number/slot number/card number/port number/E1 channel number:serial interface number". For example, the name of serial interface 3 of E1 channel 2 on CPOS0/2/0 is serial 0/2/0/2:3.

  3. Run link-protocol { ppp | tdm | hdlc | atm }

  4. Run commit

    The configuration is committed.

Download
Updated: 2019-01-02

Document ID: EDOC1100058399

Views: 17568

Downloads: 61

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next