No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic FR Functions on a DTE

Configuring Basic FR Functions on a DTE

Before deploying FR access links, configure basic FR functions on the DTE.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The FR interface view is displayed.

  3. Run link-protocol fr [ ietf | nonstandard ]

    An FR encapsulation type is configured on the interface.

    By default, the FR encapsulation type is IETF on the interface.

    NOTE:

    After the FR encapsulation type on an interface is changed, the system automatically deletes all the FR configurations on the interface. Therefore, you need to re-configure the interface.

  4. (Optional) Run fr interface-type dte

    The FR interface type is set to DTE.

    By default, the FR interface type is DTE.

    NOTE:
    After the FR interface type is changed, LMI parameters are deleted automatically.

  5. (Optional) Run fr lmi type { ansi | nonstandard | q933a }

    The LMI protocol type is set.

    By default, the LMI protocol type is Q.933a on an interface.

  6. (Optional) Configure basic parameters on the DTE.

    1. Run the timer hold seconds command to configure an interval at which status enquiry messages are sent on the DTE.
    2. Run the fr lmi n391dte n391-value command to configure the N391 parameter on the DTE.
    3. Run the fr lmi n392dte n392-value command to configure the N392 parameter on the DTE.
    4. Run the fr lmi n393dte n393-value command to configure the N393 parameter on the DTE.

  7. Run quit

    Exit from the interface view.

  8. Run interface interface-type interface-number.subnumber [ p2p ]

    The FR sub-interface view is displayed.

  9. Run ip address ip-address { mask | mask-length }

    An IP address is configured for the FR sub-interface.

  10. Run fr dlci dlci

    A DLCI is configured for the VC.

    NOTE:
    If you want to change a configured DLCI, run the shutdown command to shut down the sub-interface or delete the original DLCI.

  11. Run commit

    The configuration is committed.

Download
Updated: 2019-01-02

Document ID: EDOC1100058399

Views: 15444

Downloads: 41

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next