No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configurations

Checking the Configurations

After configuring a single-chassis LMSP group, the LMSP group's working mode, working interface, WTR time, and interface status can be viewed.

Procedure

  1. Run the display aps group group-id command to check configurations of an LMSP group.
  2. Run the commands below to check configurations of trunk interfaces.

    • Run the display pos-trunk trunk-id command to check configurations of the POS-Trunk interfaces.
    • Run the display cpos-trunk trunk-id command to check configurations of the CPOS-Trunk interfaces.

Example

# Display information about LMSP group 1.

<HUAWEI> display aps group 1
APS Group 1: Cpos0/1/0 working channel 1(Active) 
             Cpos0/2/0 protection channel 0(Inactive) 
             Unidirection, 1+1 mode, None Revert Mode 
             No Request on Both Working and Protection Side 
-------------------------------------------------------------------------------- 
Group Work-Channel Protect-Channel Wtr W-State P-State Switch-Cmd Switch-Result 
-------------------------------------------------------------------------------- 
1     Cpos0/1/0     Cpos0/2/0         NA      ok      ok         NA     idle 
-------------------------------------------------------------------------------- 
total entry: 1 
In the following example, the CPOS-Trunk interface information, including the interface status, is displayed.
<HUAWEI> display cpos-trunk 1
Interface Cpos-Trunk1's state information is:,
Operate status: up     Number Of Up Port In Trunk: 2
--------------------------------------------------------------------------------
PortName     Status     Active Status
Cpos0/1/1    Up         Active
Cpos0/1/2    Up         Inactive
Download
Updated: 2019-01-02

Document ID: EDOC1100058399

Views: 12844

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next