No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Single-Chassis LMSP

Configuring Single-Chassis LMSP

Two devices that support LMSP can be connected suing two links. Link reliability can be improved by configuring single-chassis LMSP.

Usage Scenario

Linear multiplex section protection (LMSP) needs to be configured when the Router is connected to a Radio Network Controller (RNC). As shown in Figure 13-1, PE2 and BSC (RNC) are connected using two CPOS links. You can configure CPOS 3/0/1 as a working interface, and CPOS 3/0/2 as a protection interface.

Figure 13-1 Typical networking diagram of single-chassis LMSP

Pre-configuration Task

Before configuring LMSP, configure an interface on the Router and ensure that the data link layer protocol run between the Router and the RNC is Up.

Configuration Procedures

Figure 13-2 Flowchart for configuring Single-Chassis LMSP
Updated: 2019-01-02

Document ID: EDOC1100058399

Views: 17500

Downloads: 61

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next