No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Testing the Bit Error Rate of a CE1 Interface

Testing the Bit Error Rate of a CE1 Interface

The testing results can be used to locate link faults.

Context

NOTE:

This configuration process is supported only on the Admin-VS.

When faults occur on a CE1 interface, you can run the test connectivity controller e1 command for fault locating.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run test connectivity controller e1 controller-number { unframed | channelized timeslot-list slot-list } duration time

    The bit error rate is tested on a specified CE1 interface.

Download
Updated: 2019-01-02

Document ID: EDOC1100058399

Views: 17874

Downloads: 67

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next