No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access 01

This is NE40E-M2 V800R010C10SPC500 Configuration Guide - WAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding Interfaces of an LMSP Group to a Trunk Interface

Adding Interfaces of an LMSP Group to a Trunk Interface

A working interface and a protection interface in an LMSP group must be added to a single trunk interface.

Context

LMSP is used to protect traffic on attachment circuit (AC) links connecting Routers to Add/Drop Multiplex (ADM) devices or Radio Network Controllers (RNCs) on a Synchronous Digital Hierarchy (SDH) network. AC-side physical POS or channelized Packet Over SDH/SONET (CPOS) interfaces on the Routers are added to a trunk interface to carry services.

Perform the following steps on the working and protection interfaces of an LMSP group:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface cpos-trunk trunk-id

    An CPOS-Trunk interface is created, and the view of the CPOS-Trunk interface is displayed.

    NOTE:

    LMSP can be configured on the CPOS and POS interfaces. The corresponding trunk interfaces are CPOS-Trunk and POS-Trunk. In the following example, the CPOS-Trunk configuration is used.

  3. Run quit

    The system view is displayed.

  4. Run controller cpos cpos-number

    The CPOS interface view is displayed.

  5. Run cpos-trunk trunk-id

    The interface is added to a trunk interface.

    NOTE:
    The working and protection interfaces of an LMSP group must be added to the trunk interface with the same trunk ID.

Download
Updated: 2019-01-02

Document ID: EDOC1100058399

Views: 13384

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next