No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Feature Description - LAN Access and MAN Access 01

This is NE40E-M2 V800R010C10SPC500 Feature Description - LAN Access and MAN Access

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ERPS Layer 2 Protocol Tunneling Application

ERPS Layer 2 Protocol Tunneling Application

Redundant links are used on an Ethernet switching network to provide link backup and enhance network reliability. The use of redundant links, however, may produce loops, causing broadcast storms and rendering the MAC address table unstable. As a result, the communication quality deteriorates, and communication services may be interrupted.

To prevent loops caused by redundant links, enable ERPS on the nodes of the ring network. ERPS is a Layer 2 loop-breaking protocol defined by the ITU-T. It boasts of fast convergence, implementing convergence within 50 ms.

On the network shown in Figure 12-16, Device A through Device E constitute a major ring; Device A, Device C, and Device F constitute a sub-ring; Device C, Device D, and Device G constitute another sub-ring. The ERPS ring network resides at the aggregation layer, and therefore is an aggregation ring. The aggregation ring aggregates Layer 2 services to the upstream Layer 3 network, providing Layer 2 protection switching. VLANIF interfaces are configured on Device A and Device E for Layer 3 access. VRRP is configured on the VLANIF interfaces to implement the virtual gateway function, and peer BFD is enabled for fast fault detection and accordingly fast VRRP switching.

Figure 12-16 ERPS multi-ring networking

If ERPS multi-instances are configured, ERPS is implemented in the same manner as that in Figure 12-16, except that two logical ERPS rings are configured on the physical ring in Figure 12-16, and each logical ERPS ring has its switches, port roles, and control VLANs independently configured.

Download
Updated: 2019-01-02

Document ID: EDOC1100058405

Views: 20686

Downloads: 29

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next