No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Feature Description - LAN Access and MAN Access 01

This is NE40E-M2 V800R010C10SPC500 Feature Description - LAN Access and MAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VLAN Aggregation Application

VLAN Aggregation Application

On the network shown in Figure 6-27, VLANs 1 through 4 are configured. To allow these VLANs to communicate with each other, you must configure an IP address for each VLAN on the Router.

As an alternative, you can enable VLAN aggregation to aggregate VLAN 1 and VLAN 2 into super VLAN 1, and VLAN 3 and VLAN 4 into super VLAN 2. In this manner, you can save IP addresses by only assigning IP addresses to the super VLANs.

After proxy ARP is configured on the Router, the sub VLANs in each super VLAN can communicate with each other.

Figure 6-27 VLAN aggregation application

Download
Updated: 2019-01-02

Document ID: EDOC1100058405

Views: 17941

Downloads: 23

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next