No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E-M2 V800R010C10SPC500 Feature Description - LAN Access and MAN Access 01

This is NE40E-M2 V800R010C10SPC500 Feature Description - LAN Access and MAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
QinQ-based VLAN Tag Swapping

QinQ-based VLAN Tag Swapping

On the network shown in Figure 7-7, a UPE receives user packets that carry double packets from a DSLAM. The inner and outer tags represent the service and user, respectively. However, the UPE only supports packets whose outer tag represents the service and inner tag represents the user. In this situation, you can configure VLAN tag swapping on the UPE to swap the inner and outer tags.

After VLAN tag swapping is configured, once the UPE receives packets with double VLAN tags, it swaps the inner and outer VLAN tags. VLAN tag swapping does not take effect on packets carrying a single tag.

Figure 7-7 QinQ-based VLAN tag swapping

PE-AGG: PE-Aggregation

DSLAM: Digital Subscriber Line Access Multiplexer

Service POP: Service Points-of-Presence

IPTV: Internet Protocol Television

UPE: Underlayer Provider Edge

HSI: High Speed Internet

RG: Residential Gateway

VOIP: Voice over IP

Updated: 2019-01-02

Document ID: EDOC1100058405

Views: 16349

Downloads: 18

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next