No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Feature Description - LAN Access and MAN Access 01

This is NE40E-M2 V800R010C10SPC500 Feature Description - LAN Access and MAN Access

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VLAN Mapping

VLAN Mapping

VLAN mapping, also called VLAN translation, converts between user VLAN IDs and ISP VLAN IDs.

VLAN mapping is implemented after packets are received on an inbound interface and before the packets are forwarded by an outbound interface.

  • After VLAN mapping is configured on an interface, the interface replaces the VLAN tag of a local VLAN frame with an external VLAN tag before sending the VLAN frame out.

  • When receiving the VLAN frame, the interface replaces the VLAN tag of a received VLAN frame with the local VLAN tag.

This implements inter-VLAN communication.

On the network shown in Figure 6-14, VLAN 2-VLAN 3 mapping is configured on Interface 1 of Switch A. Before Interface 1 sends a frame in VLAN 2 to VLAN 3, Interface 1 replaces VLAN ID 2 in the frame with VLAN ID 3 of VLAN 3. After Interface 1 receives a frame from VLAN 3, Interface 1 replaces VLAN ID 3 in the frame with VLAN ID 2 of VLAN 2. Therefore, devices in VLAN 2 and VLAN 3 can communicate.

Figure 6-14 VLAN mapping

If devices in two VLANs need to communicate using VLAN mapping, the IP addresses of these devices must be on the same network segment. Otherwise, devices in the two VLANs must communicate through routes, and VLAN mapping does not take effect.

The NE40E supports only 1 to 1 VLAN mapping. When a VLAN mapping-enabled interface receives a single-tagged frame, the interface replaces the VLAN ID in the frame with a specified VLAN ID.

Download
Updated: 2019-01-02

Document ID: EDOC1100058405

Views: 21043

Downloads: 29

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next