No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Installation Guide

This is NE40E-M2 V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Introduction

Introduction

On the device, the RJ45 connectors are used to input the alarm signals from the external equipment and output the local alarm signals to the equipment that monitors all the alarms.

At one end of the alarm input/output cable, the RJ45 connector is used to connect to the ALMI or ALMO interface on the equipment; at the other end, a connector (made as required on site) is used to connect to the external equipment or the equipment that monitors all the alarms.

Download
Updated: 2019-01-02

Document ID: EDOC1100058424

Views: 9505

Downloads: 49

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next