No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Installation Guide

This is NE40E-M2 V800R010C10SPC500 Installation Guide
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing E1 Cables

Installing E1 Cables

NOTE:
  • The distance between power cables, ground cables, and signal cables must be greater than 30 mm.
  • Avoid blocking boards when routing E1 cables.
  1. Attach temporary labels to both ends of each E1 cable.
  2. Route E1 cables along the cable tray, plug them to interfaces of subboards, and tighten the screws with a Phillips screwdriver.
  3. Connect the other ends of E1 cables to the DDF.
  4. Use cable ties to fasten the E1 cables to the rack.
  5. Attach permanent labels 20 mm from both ends of each E1 cable.
    Figure 8-20 Installing E1 Cables

Download
Updated: 2019-01-02

Document ID: EDOC1100058424

Views: 9266

Downloads: 45

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next