No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Installation Guide

This is NE40E-M2 V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Attaching Labels

Attaching Labels

After printing or writing a label, remove the label from the bottom of the page and attach it to a signal cable, or the identification plate of a power cable. The following section describes how to attach labels.

Signal Cable Label

  • Determine the position for a label.

    The label is attached 2 cm (0.08 in.) away from the connector of a signal cable. A label can also be attached at other positions if required, for example, to avoid the cable being bent or affecting other cables. The attached label needs to face to the right or downwards, as shown in Figure 6-5. The details are as follows:
    • If a signal cable is routed vertically, the label needs to face to the right.
    • If a signal cable is routed horizontally, the label needs to face downwards.
    Figure 6-5 Direction of an attached label

  • Procedure for attaching signal labels

    Figure 6-6 shows the methods and procedures for attaching a signal label.
    Figure 6-6 Attaching a signal cable label

Power Cable Label

Remove a label from the bottom of the page, and then attach it to the identification plate with a cable tie. The label should be stuck to the rectangular flute and should be stuck to only one side of the identification plate. The cable tie is tied 2 cm (0.08 in.) away from the connector of the power cable. A cable tie can also be tied at other positions if required.

Both ends of a cable require a label. The attached identification plate should be on top of the cable or on the right side of the cable, as shown in Figure 6-7. The details are as follows:
  • The identification plate is on the right side of the cable when the cable is routed vertically.
  • The identification plate is on top of the cable when the cable is routed horizontally.
Figure 6-7 Binding a label for a power cable

Download
Updated: 2019-01-02

Document ID: EDOC1100058424

Views: 10503

Downloads: 55

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next