No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E-M2 V800R010C10SPC500 Installation Guide

This is NE40E-M2 V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing Network Port Connectors

Installing Network Port Connectors

This section describes how to install network port connectors.

Installing Shielded Network Port Connectors

This section describes how to install a shielded network port connector.


  1. Hold the male and female connectors, with the male connector facing the female connector, as shown in Figure 4-74.

    Figure 4-74 Holding the male and female connectors

  2. Feed the male connector into the female connector until you hear a click, as shown in Figure 4-75.

    Figure 4-75 Feeding the male connector into the female connector

  3. Pull the connector gently to check that it is securely installed. Figure 4-76 shows a securely installed shielded network port connector.

    Figure 4-76 Installed shielded network port connector


    To remove a shielded network port connector, press the locking key and pull out the connector, as shown in Figure 4-77.

    Figure 4-77 Removing a shielded network port connector

Updated: 2019-01-02

Document ID: EDOC1100058424

Views: 10513

Downloads: 55

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next